Morse taper adaptor HSK 63 - 2 - 120Application: For clamping tools with Morse taper shank and thread according to DIN 228 1 form A. Delivery: With built in tightening bolt All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For highest axial and radial loading

5-30mm and 25-50mm range are supplied with setting rings

For sealing tools with internal cooling

The collet clamping Ø range is always up to 0

Hand wheel design for fine adjustment

Calibration certificate

Warranty card

Clamping range 0

For the coolant supply through the centre of  HSK toolholders

Protection level IP65

B showing the deviation of each block

Extension rod