Technical drawings. General principles of presentation - Basic conventions for representing areas on cuts and sections1 Scope This part of ISO 128 specifies general principles for representing areas on cuts and sections on technical drawings (mechanical, electrical, architectural, civil engineering etc.) following the orthographic projection methods specified in ISO 5456 2. Attention has also been given to the requirements of reproduction, including microcopying in accordance with ISO 6428. NOTE The basic rules for cuts and sections are given in ISO 128 40[1].

ISO metric screw threads BS 3643-1

What is BS EN 14399-9 - Direct tension indicators about

ISO 20766‑10 is the tenth part of the ISO 20766 series of documents that provides general design principles and specifies requirements for instructions and marking and specifies test requirements for the gas-tight housing

for fuel cell power systems with flammable gas generators relying on water reactive technology

or partially refrigerated

BS ISO 16049‑1:2020 supersedes BS ISO 16049‑1:2013

Maximum thickness has been extended to 200 mm

to zinc alloys and to copper and copper alloys to provide an attractive appearance and corrosion resistance

outside the building structure (application area code “U”)

this document is intended to be used in conjunction with ISO 5660‑1

or optical cable

It deals with electrical measurements of impulsive (short-duration) partial discharges