Credit Card ToolThis is an old design that I quite like, but hasn't been available in about six years. It is 3 16 inch thick brass and the same size as a credit card. The holes are 15 16 inch in diameter and it is lovingly ribbed for no one's pleasure. I also included a bottle opener and a wedge for prying.

At 12" in length and a 6 3/8" cutting edge of quarter inch thick 80CRV2

The handles are epoxied on and held with pins and lanyard tube (the one with micarta pins does not have a lanyard tube

These are single rings made of half inch thick brass

so these photos aren't great since they were taken on my desk

3/8" thick brass with new larger 10/32 screws and Micarta handle slabs

They are 3D printed out of ASA and have MOLLE mounts on the back

1/2" thick brass

The handles on this batch are made from G-10

Designed to hold down targets at the range during those inconvenient wind gusts

The finger hole is 1" and is elongated about 1/8" for your comfort and convenience

Cerberus has a two headed brother

Having the camera mounted outside of the vest makes a big difference in what the camera microphone picks up