Shrink chuck 4,5° HSK 100 - 20 - 120Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

For machines with rigid tapping

For machining centres without synchronous spindle

safe clamping of parallel raw and sawn parts

The clamping screw incorporates a through hole

Synchro tapping chucks compensate synchronisation errors

better chip evacuation

For longitudinal and plane turning

Powder-coated

Through hole for internal cooling provided

With balanced clamping nut All holders are made of forged steel

For use on vises

Clamping screw