Shrink chuck 4,5° with cooling channels HSK 100 - 14 - 95Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

wrench and collets

For highest axial and radial loading

For mounting straight-shank tools with lateral flat according to DIN 1835 form B (Weldon)

For safe clamping of taps in end mill holders according to DIN 1835 B

Low-vibration boring bars

Only nominal size d can be clamped (applicable up to 120 bar)

Improves chip evacuation and decreases the risk for chip jamming

With clamping screw and O-ring

With balanced clamping nut All holders are made of forged steel

tool steel

bei Ø 6 – Ø 32 mm = h238

For the chucking of quick change adaptors for taps