Hydraulic fluid power. Measurement techniques - Measurement of average steady-state pressure in a closed conduit1 Scope This document establishes procedures for measuring the average steady state pressure in a hydraulic fluid power conduit. It is applicable to the measurement of average steady state pressure in closed conduits with inside diameters greater than 3 mm, transmitting hydraulic fluid power with average fluid velocities less than 25 m s and average steady state static pressures less than 70 MPa. It is not applicable to sensors which are flush mounted

which are designed to perform the following tasks:

Software and systemsengineering

DIF slice structure

This Technical Report does not concern the substances for which restriction have been already enacted under Annex XVII of REACH

Vacuum regulator

as a material

The methodology described in this document enables:

PD CEN/TR 15126 characterizes practices and methods that can be easily performed and has widespread use in routine process control for sludge quality comparison

Note 2: BS EN 1852-1 covers a range of nominal sizes

ISO 11003-1 specifies the test procedure and test methods helps in conducting tests using butt-bonded hollow cylinders

BS IEC 62055-41:2018 supersedes BS IEC 62055-41:2014

These limitations are discussed in clause 4