End mill holder Weldon SK 50 - 16 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

Retaining screw for mounting of face mills arbors

Heat-treated steel

000 mm/min

Low-vibration boring barsWith internal coolingLonger durability of insertsFor longitudinal and plane turningSetting angle: 93°Delivery: without inserts

Measuring contact points are designed to allow measurements near to the bottom of blind holes

2x fixed and 2x steering caster

DIN 1835 form A+B+E and DIN 6535 form HA+HB+HE

Integrated pull-down mechanism

without cooling lubricant supply

bei Ø 6 – Ø 32 mm = h238

B showing the deviation of each block

With retaining screw